Series MLV20 Model 23 3-Wire

3-WAY NORMALLY CLOSED (piped)

3-Way Normally Closed 3-Wire Magnet Latching Valve — Exhaust to Atmosphere
This type of valve is often used in remote areas where continuous power may not be available or with battery-powered portable equipment where power capacity is limited. It is also valuable in equipment where coil heating, due to continuous application of power, is undesirable. Air, water and other fluids are compatible with standard Buna seals. Hot water, steam,
gasoline, oils, some hydraulic fluids, and many other media require other seal materials.

• Meets today’s demand for economy of space.
• Uses power only during latching and un-latching.
• Great for medical and chemical analyzers.

series-mlv20-model-23-3-wire.pdf

Tabs

产品规格

MAX. OPER. PRESS. DIFF.	ORIFICE SIZE	CV FACTOR		3 WIRE LEADWIRE VALVE NUMBER
DC	N.C.	N.C.	N.O.	1/8 NPT PORTS	1/4 NPT PORTS

385	1/32	.024	.024	23GG7X3LM-∆	23GG9Z3LM-∆
150	3/64	.052	.095	23HJ7X3LM-∆	23HJ9Z3LM-∆
100	1/16	.095	.095	23JJ7X3LM-∆	23JJ9Z3LM-∆
100	1/16	.156	.156	23JK7X3LM-∆	23JK9Z3LM-∆
65	3/32	.214	.156	23KK7X3LM-∆	23KK9Z3LM-∆
40	1/8	.404	.156	23NK7X3LM-∆	23NK9Z3LM-∆
20	3/16	.500	.156	23PK7X3LM-∆	23PK9Z3LM-∆

∆ - SEAL MATERIAL CODE - REPLACE ∆ WITH DESIRED CODE:

Blank = Nitrile (Buna)
S = LOW TEMP BUNA
N = FKM
E = NEOPRENE
A = EPDM

WHEN ORDERING VALVES OR REPAIR PACKS ADD VOLTAGE AND FREQUENCY TO COMPLETE VALVE NUMBER. EXAMPLES: VALVE (22J7D3LM 12/DC) REPAIR PACK (K22NDL-DC).

运行条件:

说明:

Air, water, and other fluids are compatible with standard Buna seals. Hot water, steam, gasoline, and many oils require other seal materials. (Series 20 pressure ratings may change due to the viscosity of the liquid.)*

阀门温度范围:

Standard Valves – 0°F (-18°C) to 104°F (40°C) ambient; 0°F (-18°C) to 150°F (65°C) media.

最大工作压差:

See table above.

爆破压力:

5,000 PSI

泄漏:

Bubble tight for standard valves.

真空:

To 5 Microns*

电气特性:

线圈电压:

6, 9, 12, 24 VDC

额定功率:

8.0 Watts

线圈结构:

Molded Class B with three - 24” leadwires

典型的空中响应时间:

Approximate 50 millisecond pulse to energize and de-energize.

运行速度:

Up to 600 CPM

工作周期:

Continuous

机械特性:

主体:

Stainless Steel

内部组件:

Stainless Steel

附件:

Nitrile (Buna) standard. FKM, EPDM, Neoprene and Low Temp Nitrile (Buna) are available.*

孔口直径:

See table above.

端口:

1/8” OR 1/4” NPT

列表:

Most valves are UL and CSA listed.*

预期寿命:

Millions of cycles, depending on application, lubrication, etc.

阀门重量:

1.2 lb average

修理包:

See table above.

选项:

Alternate body materials, voltages, elastomers available.*

图纸

图纸:

流程图

流程图:

Flow chart Series 20-30

Series 20 Series 30 Flow Chart

命名规则表

命名规则:

电磁阀型号编码规则（除58系列外）

* Consult representative or factory for options and specifications

Tabs

我们在此网站上使用cookie来增强您的用户体验